BAS IC FE ATU R ES OF AW I N GW 10 0 G AT EWAY
To initiate a hardware reset, disconnect power from the device and use a screwdriver to press
and hold the "reset" button, located on the front of the device. Reconnect power with the "re-
set" button pressed until the red ERR LED starts flashing. Allow the ERR LED to flash a mini-
mum of five times. Release the "reset" button and allow the gateway to reboot.
3.9
Certificates
AWIN GW100 holds the following certificates which makes it suitable for installation in haz-
ardous areas. For terms and conditions, refer to the actual certificates. For other certificates
related to regional compliance and declaration of conformity visit www.abb.com.
3.9.1
ATEX Certificate
The gateway holds the following certificate.
3.9.2
IECEx Certificate
The gateway holds the following certificate.
3.9.3
CSA Certificate
The gateway holds the following certificate.
3BN P 102 9 12 C
Figure 2: Reset button location
CER TIF IC AT E S
19