Dhcp Server; Webserver; Operator Authentication For Webserver Access; Figure 1: Awin Gw100 Gateway And Its Interfaces - ABB AWIN GW100 User Manual

BAS IC FE ATU R ES OF AW I N GW 10 0 G AT EWAY
3.2

DHCP Server

The AWIN GW100 is compatible with networks that use a Dynamic Host Control Protocol
(DHCP) server for allocating IP addresses.
3.3

Webserver

The AWIN GW100 gateway comes with built-in webserver which allows the user to both con-
figure and monitor WirelessHART network. Moreover, advanced diagnostics are also available
via the webserver.
3.4

Operator Authentication for Webserver Access

Authentication mechanisms are used to authenticate an operator accessing the device and to
verify that the operator is authorized to assume the requested role and perform services
within that role.
Access to the management screens for the AWIN GW100 gateway requires that you enter an
ID and password. The factory defaults are:
3BN P 102 9 12 C
The term WirelessHART gateway as used in this product is inclusive of three func-
tions as defined by the HART specifications.
– Gateway (see section
– WirelessHART access point (see section
– Network manager (see section

Figure 1: AWIN GW100 gateway and its interfaces

HART maintenance port (shown as HART programming tool connector) is in-
stalled but this functionality is currently not supported.
WirelessHART Gateway).
WirelessHART
Network Manager).
DHC P SE RV ER
Gateway).
17