Advertisement
5. Place the chart in the document feeding tray
(with the side having an arrow facing up).
6. Press the Start key.
7. Make sure that "Adjustment Result" is "OK."
Then, touch "SET."
8. Touch "Sub Scanning Direction 2-Side."
9. Place the chart in the document feeding tray.
Note:
Make sure that the blank surface of the chart
faces up.
10.Press the Start key.
11.Check that "Adjustment Result" is "OK" and then
touch "SET."
12.Touch "Main Scanning Direction."
4582U003AA
13.Place the chart in the document feeding tray
(with the side having an arrow facing up).
14.Press the Start key.
15.Check that "Adjustment Result" is "OK" and then
touch "SET."
16.Touch "END."
17.Touch "Exit" on the Service Mode screen.
18.Turn OFF and ON the Main Power Switch.
Note:
When displayed the Service Mode screen, be
sure to turn off the main power after exiting the
Service Mode screen and wait for 10 seconds or
more before turning on.
VII. Fixing the Stoppers
4582IXE512DA
Loosen the stopper screws (two each on the right
and left). Then, with the stoppers raised, tighten the
screws.
4582IXE513DA
E-6
4582IXE514DA
4582U008AB
4582U009AB
Advertisement
