Advertisement
5. Loosen the two front screws on the right hinge.
If the gap A is wider than gap B, move the Auto-
matic Document Feeder toward the front.
If the gap B is wider than gap A, move the Auto-
matic Document Feeder toward the rear.
Note:
Do not move the Automatic Document Feeder to
the frontmost or leftmost position.
6. Tighten the two screws.
7. Make the copy and check again.
V. Checking and Adjusting the Document
Feeding Tray Reference Position
1. Place the chart in the document feeding tray
(with the side having an arrow facing up).
2. Set up the following functions:
• Select the tray in which A4
4582U007AC
crosswise paper is loaded.
• 1-sided original
3. Press the Start key.
4. Fold the copy in half.
5. With reference to the crease, check to see if the
arrow is on the side of A or B.
Specifications: ± 2 mm from the center
* If the deviation falls outside the specified range,
use the following procedure to make an adjust-
ment.
<Metric Areas for standard line>
<Inch Areas for standard line>
E-4
crosswise or Letter
1-side copy
A
B
A
B
4582U003AA
Advertisement
