Operation - Sakai SW884 Operator's Manual

2.3 Operation

WARNING
• This machine is a one-man roller.
• Operate the machine from the operator's seat.
• Be sure to wear the seatbelt during operation.
2.3.1 Before-starting inspection
1) Check that the steering lock bar is in the carrying
position.
WARNING
Make sure that the steering lock bar is connected
in the carrying position before putting the machine
in motion. Steering is impossible if the bar is in the
steering lock position.
The bar is located at the right of the center of the
machine.
To unlock the bar
① Remove the spring pin.
② Pull out the lock pin.
③ Set the bar in the carrying position.
④ Retain the lock bar in the locked position by inserting
the lock pin into the lock holes.
⑤ Secure the lock pin with the spring pin.
2) Check that the F-N-R lever is in the neutral position Ⓝ.
3) Confirm that the parking brake is engaged.
NOTE: When the F-N-R lever is not in the neutral
(middle) position, or the parking brake has been
released, the interlocking system goes into
operation and the engine will not turn on. Be sure
to confirm that the F-N-R lever is in the neutral
(middle) position, and that the parking brake is
engaged before starting the engine.
– 47 –
2 OPERATION
Lock pin Lock bar
Spring pin
Ⓝ Neutral
Released
Applied