Chattanooga 3D ActiveTrac User Manual page 34

OpErATiON
TOuChSCrEEN CONTrOL pANEL (TCp) (CONTiNuEd)
Important Points: If the table reaches its full excursion (fully
opens) before maximum force has been reached, the force the
patient actually receives will be less than what is displayed on
the TCP. To prevent this from occurring, ensure that:
• The table is in the closed and locked position during set-up.
Unlock before pressing Start.
• The Belts and/or Harnesses fit snugly against bare skin and
do not slip.
• Monitor excursion identification markings to assure full
excursion has not been reached.
• If patient repositioning is required, you should Stop rather
than Pause the unit, so that you can close and lock the table
during repositioning. You cannot close the unit during Pause
mode unless you Pause during a Rest Time.
• If you repositioned the patient, remember to take up the
slack in the belts by pulling on the Pelvic Harness straps at
the lumbar end of the table.
32
®
3D ActiveTrac