Using The Optical Input - MAJORITY SCAFELL PIKE II Instruction Manual

Instructions Guide

Using the Optical Input

You will need: An audio source with an Optical Audio Output and a Digital
Optical Audio cable (not included)
Connect the Digital Optical Audio cable to the optical output on
the audio source and to the Optical Input on the speaker bar.
Press the POWER button on side panel (Ref.4) or POWER button
directly on the remote control (Ref.11) to switch on the unit.
Press INPUT button on the remote control (Ref.21) to switch
to Optical mode or press the SOURCE button on the soundbar
(Ref.5) repeatedly to select Optical mode. The mode indicator
LED will turn Yellow.
Using the native controls on your connected device, make
sure the audio settings are set to PCM or Optical Audio and are
turned On.
Audio from the connected audio source will now be played
through the speakers.
LINE IN AUX IN
DC 18V
OPTICAL SW.OUT
OPTICAL cable
12
LINE IN AUX IN DC 18V
OPTICAL SW.OUT
Rear view of the unit
Usin
Plug o
Line i
conn
Plug t
head
Press
direct
Press
press
enter
Audio
throu