Table of Contents
Advertisement
Troubleshooting
If the HP StorageWorks DLT80 tape drive fails during POST or operation, use
Table 8
Table 8: Troubleshooting Chart
The system does not
recognize the DLT80
drive,
DLT80 Tape Drive Reference Guide
to determine the problem and the action to take:
If
The system might not
be configured to see
the SCSI ID.
The SCSI ID might not
be unique.
The parameters for the
SCSI adapter might be
incorrect.
The SCSI signal cable
might be loose.
Then
Configure the system to see
the ID.
Change the SCSI ID and
reconfigure the system. The
new ID is effective at the next
power-on.
Check the SCSI ID adapter
installation.
Make sure the connector on
each end of the cable is
seated.
7
Action
55
Advertisement
Table of Contents
