Terminator Power
The DLT80 tape drive ships from the factory with terminator power (TERM
PWR) disabled. This allows only the controller to provide power for SCSI
termination.
Note:
If enabled, the TERM PWR setting allows the drive in addition to the controller to
provide the termination power. To enable TERM PWR a jumper must be place on
the 3 and 4 pin of the termination block located on the right side of the tape drive.
The termination power setting is shown in
Figure 5: Termination power jumper block on the right side
DLT80 Tape Drive Reference Guide
Make sure that the controller provides terminator power.
Installing an Internal DLT80 Tape Drive
Figure
5.
23