Table of Contents
Advertisement
Troubleshooting
Note:
BHC test will not run and the density LEDs return to their original state.
3. If the test passes, the top four density LEDs illuminate steadily for five
4. If the test fails, the top four density LEDs flash on and off for five seconds,
If the BHC test fails, hardware failure is likely. Contact the HP Technical Support
Center for help. See the "About This Guide" section for information on contacting
the support center.
Upgrading Firmware
The HP Library and Tape Tool (L&TT) is a tape management and diagnostic tool
to help you install and support your HP storage product. In addition to the
diagnostic and troubleshooting ability of L&TT, it offers useful information about
your products and provides automated firmware update checks from the Internet,
with the ability to retrieve the latest firmware versions.
Complete instructions and download of L&TT are available at:
www.hp.com/support/tapetools
58
If the Density Select button is not released then momentarily pressed again, the
seconds, then return to their original state.
then return to their original state.
DLT80 Tape Drive Reference Guide
Advertisement
Table of Contents
