Setting The Scsi Id - HP StorageWorks DLT80 Reference Manual

Setting the SCSI ID

Each SCSI device on the same SCSI bus must have a unique SCSI ID. Avoid
duplicating the SCSI ID when assigning it to the DLT drive. Use the factory-set
default SCSI ID 6.
To change the SCSI ID, press the switch on the rear panel of the drive above or
below the number display to set the desired number.
Note:
Note:
Figure 12: Setting the SCSI ID switch on an external DLT80 drive
DLT80 Tape Drive Reference Guide
The SCSI ID can be set up to 15 but a SCSI ID above 6 is not recommended.
SCSI ID 7 is reserved for the controller.
Connecting an External DLT80 Tape Drive
6
31