Power indicator codes
Hard drive indicator codes
Each hard drive carrier has an activity indicator and a status indicator. The indicators provide information about the current status of the
hard drive. The activity LED indicates whether the hard drive is currently in use or not. The status LED indicates the power condition of
the hard drive.
Figure 12. Hard drive indicators on the hard drive and the hard drive tray backplane
1. Hard drive activity indicator
3. Hard drive backplane on hard drive tray
Table 12. Hard drive indicator codes
Hard drive status indicator code
Flashes green twice per second
Off
Flashes green, amber, and then turns off
Flashes amber four times per second
Solid green
Locating the serial number of your appliance
To get support for your appliance, use the VxRail Appliance serial number, also called the Product Serial Number Tag (PSNT). The PSNT is
a 14-digit number used to identify your appliance to Dell EMC support.
14
Overview
Condition
CAUTION:
When correcting a PSU mismatch, replace only the PSU with the blinking
indicator. Swapping the PSU to make a matched pair can result in an error condition and
unexpected appliance shutdown. To change from a High Output configuration to a Low
Output configuration or vice versa, you must turn off the appliance.
CAUTION:
If two PSUs are used, they must be of the same type and have the same
maximum output power.
CAUTION:
Combining AC and DC PSUs is not supported and triggers a mismatch.
2. Hard drive status indicator
4. Hard drive
Condition
Identifying drive or preparing for removal.
Hard drive ready for removal.
NOTE:
The hard drive status indicator remains off until all
drives are initialized after the appliance is turned on. Hard
drives are not ready for removal during this time.
Predicted drive failure.
Hard drive failed.
Hard drive online.