Physical Installation - SeaLevel PLC-16.PCI User Manual

6. Unmount the drive and then Unzip and Untar the drivers and software by typing:
umount /cdrom
tar -xvzf seaio .tar.gz
7. Change to the SeaIO directory by typing:
cd SeaIO
8. Now compile and prepare the drivers for use:
make install
9. With the system off and unplugged, install your SeaIO PCI card.
10. Plug system back in and boot Linux.
Login as "root".
11. Load the driver by typing:
SeaIO -load
The driver has enabled the card and is ready to use, and you now have the option to run a test utility on it. Skip to
section "Using the test software" if you wish to do so at this time.
To set up Linux to automatically load the driver; refer to a Linux manual concerning your specific distribution for
help.

Physical Installation

The adapter can be installed in any 5V PCI expansion slot.
Do not install the Adapter in the machine until the software has been fully installed.
1. Turn off PC power. Disconnect the power cord.
2. Remove the PC case cover.
3. Locate an available PCI slot and remove the blank metal slot cover.
4. Gently insert the PCI adapter into the slot. Make sure that the adapter is seated properly.
5. Replace the screw. (This is required to ensure FCC Part 15 compliance.)
6. Install cable (CA165).
7. Replace the cover.
8. Connect the power cord.
Installation is finished.
.
Sealevel Systems PLC-16.PCI
Installation
Page 3