Table of Contents
Advertisement
2 Completing the operation
Read the notes that follow before proceeding.
Note: Follow the instructions on the panels to
complete the operation.
Note: If no errors are detected, the following will
happen.
A message may display stating "the internal
code changes were installed and activated
as requested." Select OK to close the
window. Press Esc until the Setup
Installation Options panel is displayed.
Select End set up. If no message displays
double click on System Information from
the Change Management area to see that
the code changes were installed..
OR
Your Support Element may re-initialize. If
this happens, wait until the Hardware
Management Console Workplace panel
displays and The Support Element has
re-initialized. When complete, go to
"Establishing a CPC Console Connection"
on page 6-26.
Note: If errors are detected during this procedure,
the Hardware Messages icon will be
flashing. Correct the problem (see The
Hardware Messages icon on page 6-18,
then retry this procedure.
Chapter 6. Completing the Installation
6-25
Advertisement
Table of Contents
