Ducati Monster 821 Owner's Manual page 83

LAP recording
With the LAP function "active", it is possible to record
the Lap time.
To record the lap time it is necessary to activate the
LAP TIME function through the Setting Menu in the
LAP page.
After enabling this function, lap time can be recorded
as follows:
- the first time the rider presses button (3), the
"timer" of the first lap starts and "START LAP" will
be displayed flashing for 4 seconds in MENU 1:
then the previous function will be displayed
automatically;
- from this moment, whenever button (3) is
pressed, the instrument panel will show
automatically the lap time in MENU 1 for 10
seconds and the LAP "number" instead of the
engine coolant temperature indication: after 10
seconds it will display the previous function.
30 laps max. can be recorded.
If the instrument panel "memory" is full, whenever
button (3) is pressed, the instrument panel does not
record any lap time and "FULL -- LAP" will be displayed
flashing for 4 seconds until lap times are reset. This
82
indication will be displayed until all times are reset
with the LAP erase function in the Setting Menu
(ERASE).
When the LAP function is set disabled, the current
"lap" is not stored.
If the LAP function is active and the motorcycle is
suddenly turned off (Key-Off), the function will be
automatically disabled: even if the lap timer was
active, the current "lap" is not stored.
If the time is never "stopped", it will roll over upon
reaching 9 minutes, 59 seconds and 99 hundredths;
the lap timer starts counting from 0 (zero) and will
keep running until the function is disabled.
If however the LAP function is switched on and the
memory has not been cleared, but fewer than 30 laps
have been saved (e.g. 18 recorded laps) the
Instrument Panel records any left lap until memory is
full (for instance: 12 further laps can be recorded).
In this function only the lap times being recorded are
displayed; other data are anyway recorded (MAX
speed, MAX rpm and limiter if reached), which can be
later displayed with the "Stored LAPs displaying"
function (LAP REC) in the Setting Menu.