Troubleshooting - Nassenheider Fill Up 2 visco Manual

nassenheider
fill up

11.3 Troubleshooting

Error
Malfunction of the software effect of strong electromagnetic
The medium is filled with
air bubbles
Pump motor is turned on, but
does not turn easily, or does
not turn at all.
Fault warning: overload
Inaccuracies
when filling
More tips and tricks:
see our homepage www.nassenheider.com at Service → FAQ.
At the service page you can also find other technical documents and
manuals in serveral languages
© Stefan Weiland 15.11.2012
Manual
Reason
fields (mobile phone, cordless tele-
phones, or another motor was not
screened off from the agitator)
Some large air bubbles in the honey
cannot be completely removed be-
cause the honey stream enters the
jar in concentric circles and so al-
lows large air bubbles in.
Retract is too long, so that some air
bubbles are always sucked back into
the fill nozzle during retraction (ap-
plies mainly to liquid honey)
Leakages in the suction connections Check the bolt connections, sealing
Blockage of the gear wheels with
hardened honey or some other for-
eign object: motor protection is acti-
vated. Can happen after long filling
breaks (e.g. over night):
- Honey is too cold
- Honey has crystallized
If there is a foreign object in the
pump head, the gear wheels are
blocked (e.g. nuts.)
Air pockets
Medium cannot flow through suction
hose and bent pipe fast enough
(especially a problem with rapeho-
ney). You can see this, when tiny va-
cuum pockets are building up in the
upper part of the pump head (easily
visible through the transparent pump
head cover).
Solution
Reset to factory settings
Menu SETUP → RESET →
Place the equipment as far down as
possible, so that the filling nozzle is
very close to the edge of the jar and fill
the honey as liquid as possible (warm).
reduce retraction period.
Rule of thumb:
0-1: liquid medium such as oil or
other liquid solutions
2-3: liquid, freshly extracted honey,
mustard, thick sauces
4-5: creamed honey
rings and sensitive places at the pro-
blem area before applying with a honey
coating (see Fig. 4.2, page 12).
Remove cause (clean machine,
place in warm room etc.).
Acknowledge with , when machine
is working again
See above
Use bigger suction hose-Ø and bent
pipe
Reduce viscosity of the medium (e.g.
through raise of temperature of the ho-
ney to 25 – 30°C/ 77 - 86°F)
Keep the suction hose as short as pos-
sible
Slow down motor speed to approx.
40/min. That way the machine is adjus-
ted to the rate of flow of the honey insi-
de the hose.
Fill Up 2
Page 26