External Switches - Nassenheider Fill Up 2 visco Manual

nassenheider
fill up

10.5 External switches

All external switches are inserted into the 5-pin socket on the left side of the
driving module.
The microswitch (Art.No. 307006, fig. 7.2 a) is adjusted in such a way that
it releases the renewed filling procedure when placing the next jar into the y-
frame. This switch is only used in AUTO mode.
The foot switch (Accessory Art.No. 303001, fig. 7.2 b) is connected in all
modes of operation, parallel to the
exactly the same functions. It can be ordered as an accessory.
To avoid any unintentional filling up procedure, microswitch or
foot switches should only be attached when all preparation
(suction and calibration) has been finalized, before filling.
Niveau switch (Accessory Art.No. 303004, fig. 7.2 c)
Moving freshly extracted honey from the cleaning basin into a larger tank
(e.g. onto a shelf) can be controlled by the float switch.The switch can be
hung with the mounting plate onto a container. The metal strip may need
to be shortened.
Used as in (A):
- With rising level of liquid the motor is switched on.
- Use in the cleaning basin after the honey extractor
- Motor always starts, when sufficient honey has run out of the centrifuge
Used as in (B):
- With rising level of liquid the motor is switched off
- Used in the tank to be filled (prevention of tank to be filled overflowing)
The mode of operation to be chosen here is:
PUMP → INTERVAL FOREWARD or BACKWARD
Microswitches, foot-switches and niveau-switches are water-
proof (Protection level IP 67) and can be immersed into water
for cleaning.
© Stefan Weiland 15.11.2012
Manual
- key of the keyboard, witch has thus
Fill Up 2
fig. 7.2 a
Bügelschalter
fig. 7.2 b
Fußschalter
fig. 7.2 c
Schwimmerschalter
(A):
(B)
:
Page 24