Maintenance And Service; Daily Maintenance - SaMASZ PG 150 Operator's Manual

6. MAINTENANCE AND SERVICE

CAUTION
Use only original SaMASZ fittings and spare parts. Spare parts of unknown
origin or new made are of less strength and have unfavourable influence the
on machine's overall performance and safety.
CAUTION:
The SaMASZ co. shall not bear any responsibility for damages and defects
caused as a result of applying non-genuine parts and fittings.

6.1. Daily maintenance

Each time before operating the machine do the following:
make sure that both the tractor and the extension arm, which the machine is mounted on, work

properly,
examine bolt connections of cutting disk, knife holders, knives and tighten if necessary,

examine torque of all bolts and nuts,

tighten set screws so as to remove play between cutting bars

examine condition of hoses and hydraulic connections,

examine condition of cutting bars, and if needed, order their recovery or replace,

replace damaged parts,

lubricate all lubrication points marked with special label

After 4-5 hours of operation:
check the play between cutting bars, and if needed correct using set screws for upper cutting

bar,
check for any loosened bolts, and if needed tighten using torque values,

examine condition of hoses and hydraulic connections,

examine cutting bars for function,

lubricate.

Once operation with the trimmer is complete, do as follows:
clean and wash thoroughly,

if needed, lubricate all lubrication points marked with special label as in Fig. 6.

Operator's manual
:
Fig. 6. Lubrication point
- 16 -
SCISSOR TRIMMER
PG 150 (F), PG 200 (F)
PG 150L (F), PG 200L (F)
as in Fig. 6