Replacement Of Damaged Or Worn Parts; Storage; Qualifications Of Operator; Transport - SaMASZ PG 150 Operator's Manual

4.1.5. Replacement of damaged or worn parts

Any works related to replacement of worn or damaged parts should be done only after the

machine has been switched off, and having previously learned the contents herein.
After the engine has been turned off and the ignition key removed, the vehicle should be

secured against any accidental movement.
When conducting repair works or replacing worn or damaged parts wear protective gloves,

protective footwear as well as protective clothing without any loose elements.
When operating with the machine lifted up, protect it properly with supports and when replacing

parts with sharp edges, use personal protective equipment and corresponding tools.
Once works related to replacement of defective parts are completed, mount back all elements of

guards and safety devices.
CAUTION:
During replacement of working parts, it should be used personal protective
gloves.

4.1.6. Storage

Scissor trimmer should be stored under a roof and protected against access of animals and

unauthorised persons who could get injured.

4.1.7. Qualifications of operator

To provide safe machine operation each person being the machine operator must meet the
following requirements:
Operator should hold driving license, have ability to drive vehicles safely and know road traffic

rules.
Operator must be in proper physical condition to be able to operate the machine.

Operator must not be under the influence of alcohol, drugs and medicines, which all have

influence on vehicle driving and machine operation.
Operator should be familiarized with this manual and follow its provisions.

Operator should be familiar with working principles of both the tractor and the machine, and be

able to recognize and avoid hazards resulting from operation of the aggregate.

4.1.8. Transport

When driving on public roads always respect the local traffic regulations.

For transport of the aggregation of arm and machine, remove or partially disconnect the PTO

shaft from the tractor's side.
For transport protect blades on the machine with an additional protective guard.

While transporting the above aggregation mount remote warning light device and warning

triangle for a slow driving vehicle.
During transport, always set the scissor trimmer in its proper and safe transport position.

Any modifications in the machine's position are possible only if no vehicles or unauthorized

personnel are around (children in particular).
Do not drive over 25 km/h (15 mph).

While transporting, if hydraulics are damaged, the extension's arm cylinder should be protected

with a special lock (channel section on the cylinder's rod).
Operator's manual
- 8 -
SCISSOR TRIMMER
PG 150 (F), PG 200 (F)
PG 150L (F), PG 200L (F)