Using Of The Scissor Trimmer; Attaching The Scissor Trimmer To The Extension Arm; Transport Position And Drives - SaMASZ PG 150 Operator's Manual

CAUTION:
Spare assemblies used for the scissor trimmer repair should hold all warning
labels provided by the manufacturer.

5. USING OF THE SCISSOR TRIMMER

5.1. Attaching the scissor trimmer to the extension arm

In order to mount scissor trimmer on extension arm do the following in a sequence:
place pallet with scissor trimmer on an even and paved ground,

drive the tractor with the attached extension arm and position the mounting plate of the arm so it

matches the scissor trimmer's mounting plate,
secure the tractor against moving,

bolt trimmer's mounting plate to the arm's mounting plate with bolts and M14 nuts,

connect hydraulic hoses using push-in fittings while paying particular attention so that the

scissor trimmer's supplying hose is connected to the supply connector P(+) of the extension arm
and the scissor trimmer's return hose to return connector T(-) of the extension arm,
lift up the connected scissor trimmer slightly above the pallet and check all bolt connections and

whether there are no apparent damages,
take off the cutting bars cover and next pre-start scissor trimmer in order to check whether

connections and operation are correct.
CAUTION:
When connecting and inspecting the scissor trimmer, follow any and all safety
conditions provided herein.

5.2. Transport position and drives

Transport position of scissor trimmer aggregated with SaMASZ extension arm corresponds to
the arm's transport position. See.
When mounting the scissor trimmer on other type of extension arm, fold the scissor trimmer
aggregated with the arm in the position as compact as possible.
To transport the aggregation of arm and scissor trimmer, use any protective means as intended

for control and design of the extension arm.
Dismount the PTO shaft for transport.

Provide proper marking and lighting of the aggregated machines for a low-speed vehicle to

comply with road traffic provisions.
Driving speed should always be adjusted to current road conditions.

Transport speed on public roads cannot exceed the mean speed of 25 km/h (15 mph).

Operator's manual
Fig. 4. Markings of hydraulic hoses
- 13 -
SCISSOR TRIMMER
PG 150 (F), PG 200 (F)
PG 150L (F), PG 200L (F)