Inspection And Repair - SaMASZ PG 150 Operator's Manual

Scissor trimmer should be operated with the PTO shaft running at 300-350 rpm (applicable for

the SaMASZ extension arm).
Perform any manoeuvring of the scissor trimmer only from the operator's seat. Do not control

the machine from outside the tractor's cabin.
The operator is not allowed to leave the tractor while driving.

Operate the scissor trimmer only when the tractor is not moving, and move the scissor trimmer

only by the extension arm and adjust the operation to conditions such as size and number of
scissor trimmer to be ground.
Low speed is recommended. During work at higher speed, the scissor trimmer and the extension

arm may be destroyed.
Do not operate the scissor trimmer after dusk.

Do not leave the aggregation of tractor and extension arm on slopes or other inclinations

without providing any additional protection.
Do not operate with damaged or missing guards (Journal of Laws No. 12/98 item 51.)

In case of a fatal failure, stop the machine's drive, turn the tractor's engine off and take out the

ignition key. Then call for technical service, and if an accident (in this case: road accident)
occurs, respect first aid rules and contact responsible authorities.

4.1.4. Inspection and repair

Perform any inspection, repair and maintenance works as well as cleaning parts or assemblies

when the drive is switched off and there is no pressure in the hydraulics, having taken the
ignition key off and set the aggregation of tractor and machine in a standstill position (Journal
of Laws No. 12/98 item 51.)
Inspect bolts and other fasteners regularly. Do not operate with damaged or worn fasteners.

Do not operate with damaged or worn fasteners. When the rubber guard shows signs of ageing

(e.g. micro cracks over the surface), it should be replaced.
Do not perform any repair works underneath the lifted machine's assemblies, unless protected

against free falling (Journal of Laws No. 12/98 item 51.)
Replace damaged or worn (aged 5 years or older) hydraulic hoses and other hydraulic parts as

recommended by the Manufacturer.
Never repair damaged hydraulic hoses with tape.

Do not perform any repair works underneath the lifted machine's assemblies, unless protected

against free falling (Journal of Laws No. 12/98 item 51).
Before any operation, check the condition of cutting knives. If blunt, rotate the knife by 1/3 turn

(3 sharp cutting edges per a single knife can be achieved), or handle it for a recovery. Damaged
or worn blades must be replaced.
Use only original spare parts ordered at our store or at your dealer.

During operation, maintenance and adjustment, always wear protective gloves, shoes and

clothing without loose elements, belts, etc. Always respect warnings on safety labels attached to
the machine.
When operating the hydraulics, always wear protective eyewear and gloves. Hydraulic oil

leaking under pressure (16 MPa) may penetrate the skin and cause its irritation thereafter. In
such case, visit a doctor immediately.
In the event of a serious failure, please call for technical service, and if an accident (in this case:

road accident) occurs, respect first aid rules and contact responsible authorities.
CAUTION:
Before maintenance and repair the machine, turn off the engine of tractor. All
rotating parts should be stopped.
Operator's manual
- 7 -
SCISSOR TRIMMER
PG 150 (F), PG 200 (F)
PG 150L (F), PG 200L (F)