Putting The Machine Onto Another Vehicle For Transport; Hydraulic Assembly - SaMASZ PG 150 Operator's Manual

4.1.9. Putting the machine onto another vehicle for transport

Both the driver and the carrier are responsible for the machine's safe transport. Any equipment
and parts must be secured for transport. The following rules should be observed when placing a
machine onto a transport vehicle:
Using lifting devices grab only stiff elements on the machine such as housing and mounting

plate.
In order to lift the machine, use only lifting devices of hoisting capacity bigger than the

machine's weight provided on the data plate.
When the machine is to be transported, make sure to install the guard on cutting bars.

On the vehicle's trailer, the scissor trimmer should be protected against moving.

When the machine is to be transported, make sure to install the guard on cutting bars. Cover the
machine with bubble foil and fix it on a pallet with duct tape. Any further moving of the machine
should be done with the fixed pallet, considered as its integral part.
To place the scissor trimmer on a pallet use belt suspension and lifting device with capacity of
no less than the trimmer's weight.
CAUTION:
The person in charge of the machine's transport shall be responsible for
securing the danger area and performing the work.

4.1.10. Hydraulic assembly

Caution! Hydraulic assembly is under pressure! Hydraulic oil under pressure may permeate

through skin and cause serious injury, therefore skin and eyes should be protected in particular.
In case of injuries caused by a liquid under pressure, call a doctor immediately.
Hydraulic hoses can be connected to tractor's hydraulics, provided that both the extension arm's

and the trimmer's hydraulic assemblies are not under pressure. To remove the pressure from the
hoses just simply restart the tractor's hydraulic valves several times, once the tractor is off.
When dismounting the machine from the tractor, set the equipment aside, deflate the pressure

from hydraulics and turn tractor's engine off.
When controlling for hydraulic assembly's malfunction and looking for oil leaks, it is forbidden

to touch any potential leaks until the entire assembly is under pressure.
Note! It is recommended to use hydraulic oil featuring oil purity class <10 in accordance

with NAS 1638.
When using hydraulic hoses:
Avoid stretching the hoses when operating.

Do not allow hydraulic hoses to get deflected.

Do not expose hydraulic hoses to contact with any sharp edges.

If damaged or worn, replace the hoses with new ones.

Useful life for hydraulic hoses is 5 years from their production date.

Operator's manual
- 9 -
SCISSOR TRIMMER
PG 150 (F), PG 200 (F)
PG 150L (F), PG 200L (F)