Sony FLEXICART BFC-1 Installation Manual page 29

1. Rack mount rail installation
(1) As shown in the figure, install the guide pin (each on the
right and left) in the frame of the direction in which the VTR
is pulled out. Pay attention to the relation of the installation
position between the guide pins and outer rail assembly fix-
ing screws. (Adjust the pin to the 1U-marked frame on the
right.)
[Reference]
For the installation position, refer to the figure on the pre-
ceding page.
(2) As shown in the figure, install the guide plate in the frame,
opposite to the direction in which the VTR is pulled out,
with two screws (each on right and left). Adjust so that the
screw hole at the top of the guide plate is the same in height
as the guide pin installed in step (1). (Adjust the plate to the
1U-marked frame.)
Note: For both front and rear drawer types, guide plate
(R) must be installed on the right toward the
front of a cart machine.
Be sure to remove the two installed guide plates
after the front drawer-type VTR is mounted.
(Refer to step (8) of procedure 2.)
(3) Pull out the outer rail from the rack mount rail assembly and
loosen the two screws (bracket fixing screws) shown in the
figure.
BFC-1
GUIDE PIN
VTR DRAWING DIRECTION
GUIDE PLATE (R)
1U MARK
FRAME
GUIDE PLATE (L)
SCREWS
(+B5x10)
SCREWS
(+B5x10)
. . BKFC-52
Do not loosen these screws.
OUTER RAIL ASSY
OUTER
MEMBER
FRAME
VTR DRAWING
DIRECTION
SCREWS
4-13