Sony FLEXICART BFC-1 Installation Manual page 28

VTR installation position
Install the rack mount rail and reference pins according to the procedure while referring to the figure below.
. . When DVR-10/20 series (6U) are installed.
There are marks on this line every 1U.
The height of guide pin and attachment holes for
bracket (upper) are always equal to this mark.
Rack mount kit can be attached even if it is shifted
1/2U, but shutter plate can not be attached.
HOLES FOR
BRACKET
ATTACHMENT
DVR-10/20 SERIES
( )
BETACAM SERIES
VTR
( DVR-10/20 SERIES )
HOLES FOR BRACKET
ATTACHMENT
(LOWER)
LOWEST HOLE
4-12
GUIDE PIN
(DRAWING SIDE)
GUIDE PIN
(DRAWING SIDE)
FL
. . When DVR-18/28 series (8U) are installed.
HOLES FOR
BRACKET
ATTACHMENT
(DVR-18/28)
HOLES FOR
BRACKET
(LOWER)
LOWEST HOLE
GUIDE PIN
(DRAWING SIDE)
GUIDE PIN
(DRAWING SIDE)
FL
Unit : mm
(1U = 44.45 mm)
BFC-1