Janome 5300QDC Instruction Book page 27

z
x
z
x
z
x c v b n
w
q
m
r e
t
Setting Mode
To enter the setting mode, press and hold the memory
key and turn the power switch on until the setting mode
screen appears.
In this mode you can set the following machine functions.
The buzzer sound can be turned on or off using the
buzzer sound setting. The default buzzer sound
setting is "ON".
z Enter the setting mode.
x To turn off the buzzer sound, press the cursor key
and the "oF" mark will blink. Press the memory key
to turn the buzzer sound off.
* Caution buzzer sound cannot be turned off.
You can set the needle position to up or down when
the machine stops.
z Enter the setting mode. Press the mode key to
enter the up/down needle position setting.
x The default up/down needle position setting is "dn".
To change the needle position, press the cursor
key and the "UP" mark will blink. Press the memory
key to change the up/down needle position to "UP".
key sensor is off from the actual key position.
z Enter the setting mode. Press the mode key twice
x
"P1" is shown on the right side of the screen. With
a buttonhole opener, press q on the touch panel
of your machine.
c "P2" will be shown on the LCD display. Press the
w on the touch panel.
v "P3" will be shown on the LCD display. Press the
e on the touch panel.
b "P4" will be shown on the LCD display. Press the
r on the touch panel.
n "P5" will be shown on the LCD display. Press the
t on the touch panel.
m The screen will back to the initial screen of the
25