Do you have a question about the myLock 534 and is the answer not in the manual?
Questions and answers
May
January 29, 2025
How to adjust the blade on a Janmone overlock 534D
1 comments:
Mr. Anderson
February 10, 2025
To adjust the blade on a Janome MyLock 534D serger, follow these steps:
1. Turn Off the Machine – Unplug the machine for safety.
2. Open the Front Cover – Locate the blade assembly by opening the front cover of the serger.
3. Lower the Upper Blade – If necessary, turn the handwheel gently to lower the upper blade into its cutting position.
4. Loosen the Upper Blade Screw – Using a screwdriver, slightly loosen the screw holding the upper blade in place. Do not remove it completely.
5. Adjust the Blade Position – Move the upper blade up or down to change the cutting width. Ensure that the upper blade meets the lower blade correctly for clean cuts.
6. Tighten the Screw – Once the blade is properly aligned, tighten the screw securely.
7. Check the Cutting Action – Slowly turn the handwheel to ensure the upper blade moves smoothly against the lower blade.
8. Test with Fabric – Run a piece of fabric through the machine to verify the cutting performance. Adjust again if necessary.
9. Close the Front Cover – Once satisfied with the adjustment, securely close the front cover.
Always refer to the user manual for specific instructions related to your machine model.
Need help?
Do you have a question about the myLock 534 and is the answer not in the manual?
Questions and answers
How to adjust the blade on a Janmone overlock 534D
To adjust the blade on a Janome MyLock 534D serger, follow these steps:
1. Turn Off the Machine – Unplug the machine for safety.
2. Open the Front Cover – Locate the blade assembly by opening the front cover of the serger.
3. Lower the Upper Blade – If necessary, turn the handwheel gently to lower the upper blade into its cutting position.
4. Loosen the Upper Blade Screw – Using a screwdriver, slightly loosen the screw holding the upper blade in place. Do not remove it completely.
5. Adjust the Blade Position – Move the upper blade up or down to change the cutting width. Ensure that the upper blade meets the lower blade correctly for clean cuts.
6. Tighten the Screw – Once the blade is properly aligned, tighten the screw securely.
7. Check the Cutting Action – Slowly turn the handwheel to ensure the upper blade moves smoothly against the lower blade.
8. Test with Fabric – Run a piece of fabric through the machine to verify the cutting performance. Adjust again if necessary.
9. Close the Front Cover – Once satisfied with the adjustment, securely close the front cover.
Always refer to the user manual for specific instructions related to your machine model.
This answer is automatically generated