Wieland Samos Pro Compact SP-COP1 Instruction Manual page 10

If serveral modules are mounted: Adjacent modules have to be
connected by pushing them into the designated direction until
they are snapped together.
Install termination parts beside the system.
4.1.3 After Installation
The following steps are necessary after all the modules have been
installed:
Establish the electrical connections
Configuration (operating instructions for "samosPLAN5 + pro-
gramming software")
Test the installation
4.2 Steps of deinstallation of the modules
Switch off the power supply for samos
Remove the plug-in block terminals with the wiring [A] and their
end clips [B].
If several modules are present, push the modules individually apart
in the direction of the arrow, until the side plug-in connection is
disconnected.
Unlock the modules.
Using a screwdriver, pull the locking slide back to unlock the
module.
10 10 10 10
® PRO
Tilt the module slightly away from the standard rail and remove it
from the standard rail in the direction of the arrow.
4.2.1 Removing extension modules
Remove the plug-in block terminals with the wiring [A] and their
end clips [B].
If several modules are present, push the modules individually apart
in the direction of the arrow, until the side plug-in connection is
disconnected.
Press on top of the module from above and tilt the modul in
pressed state [D] away from the standard rail
Wenn mehrere Module vorhanden sind:
Schieben Sie die Module in Pfeilrichtung [C] einzeln auseinander,
bis die seitliche Steckverbindung getrennt ist.