Table of Contents
Advertisement
2
Control Panel (Fig.2)
（
）
⑭Digital Speed Indicator(Speed)
Ｋ Load Monitor Lamp (LOAD)
Ｊ Internal Lamp
Ｉ External Lamp
⑫Motor Speed Selection Switch
⑨Start Switch
Starts and stops motor rotation
⑩Forward/ Reverse Switch
This switch controls the direction of rotation,
forward (FWD) or reverse (REV). With the cutting
tool facing the operator right hand rotation (FWD)
will be clockwise rotation.
⑪Controller Switch (AUTOーMANUAL)
This switch selects motor/spindle control from the
Control Panel or from an external source.
●MANUAL : Control Panel
●AUTO : External control through the input/
output connector CN2②
⑫Motor Speed Selection Switch
Select the motor speed control mode. Internal unit
(INT), External (EXT), Centering (500)
⑬Speed Adjustment Knob
Steplessly adjustable speed control. If the knob is
turned clockwise, this will increase motor speed.
Motor speed is adjustable: 20,000-80,000min
7
Ｇ Auto Lamp
Ｈ 500 Lamp
Ｆ Manual Lamp
Ｂ Power Lamp
Ａ Error Lamp
Ｅ REV.Lamp
Fig.2
⑭Digital Speed Indicator (SPEED)
Preset Speed, Actual Speed, Warning and Error
Codes are displayed to 2 digits.
A
Error Lamp：When an error exists this lamp lights
and the error code is shown on the digital display.
B
Power Lamp：Power Switch is in the ON position.
C
Motor Lamp：Motor is rotating (except at the
minimum of speed adjustment knob)
D
FWD. Lamp：Forward rotation is counter-clockwise
rotation when the cutting tool is facing the operator.
E
REV. Lamp：Reverse rotation is clockwise rotation
when the cutting tool is facing the operator.
F
Manual Lamp：Manual operation
AUTO Lamp：Auto operation
G
H
500 Lamp：500min
I
EXT Lamp : Motor Control by external signal
source.
J
INT Lamp : Motor Control by front panel controls.
K
Load Monitor Lamp (LOAD) : Real time load
-1
.
monitoring display.
⑬Speed Adjustment Knob
Ｃ Motor Lamp
D FWD. Lamp
⑨Start Switch
⑩Forward/Reverse Switch
⑪Controller Switch（AUTOーMANUAL）
-1
operation for centering
Advertisement
Table of Contents
