Nakanishi E800Z Operation Manual page 7

Nomenclature
5
Fig.1
Control unit (Fig.1)
（ ）
1
①Input/Output Connector CN1
This is the connector for automatic control
and monitoring of the control unit's safety
systems. When this connector is not being
used, please install the provided connector
cover.
②Input/Output Connector CN2
This is the connector for automatic control
and monitoring of the motor/spindle's
systems. When this connector is not being
used, please install the connector cover.
③Motor connector
④Cooling air output joint
Connect air hose to supply cooling air to the
motor
⑤Power Supply Voltage Selector Switch
115V or 230V power sources can be
selected by use of this switch.
①Input/Output Connector CN1
②Input/Output Connector CN2
③Motor Connector
④Cooling Air Output Joint
⑤Power Supply Voltage Selector Switch
⑥Air Input Joint
⑦Main Power Inlet with Fuse Holder
⑧Power Switch
⑥Air Input Joint
Supply clean, dry, regulated air for motor
cooling. The air supply needs to be regulated
between 0.2MPa-0.5MPa. Air consumption
is 30N R /min (At 0.5MPa)
⑦Main Power Inlet with Fuse Holder
Insert the provided power plug (Fuse 2pcs:
250V-T3.15A Order No.:U195-152)
⑧Power switch
6