１．Cautions For Handling And Operation - Nakanishi E800Z Operation Manual

Thank you for purchasing the Ultra-Precision, High-Speed spindle system, E800Z. E800Z
System is designed for use on CNC lathes, robots, NC lathes and special purpose machines.
The motor, spindle and control unit are designed to work as an integrated system capable
-
of 0-80,000min . This system utilizes air to cool the motor and protect the spindle from
1
contaminants, please use an airline kit to ensure that clean, dry, properly regulated air is
supplied to the motor and spindle. Please read this Operation Manual carefully prior to use.
Cautions for handling and operation
1
Read these cautions carefully and only use in the manner intended.
■
Safety instructions are intended to avoid potential hazards that could result in personal injury or
■
damage to the system. Safety instructions are classified as follows in accordance with the
seriousness of the risk.
Class
A hazard that could result in bodily injury or damage to the system if the
WARNING
safety instructions are not followed
！
A hazard that could result in light to moderate bodily injury or damage to the
CAUTION
！ system if the safety instructions are not followed.
WARNING
！
The E800Z is not a hand tool. It is designed to be installed on a NC lathe or a special
①
purpose machine.
DO NOT connect or disconnect the electric cord or operate E800Z with wet hands. Failure
②
to follow this warning may result in electric shock.
Protect E800Z control unit from coolants and moisture contamination. Failure to protect
③
the control unit can result in damage to internal components and short-circuits within the
E800Z control unit and possible injury to the operator or other personnel.
Always use a protective cover around the spindle, wear safety glasses, dust mask,
④
hearing protection and gloves while the motor is running.
Never touch the motor, spindle or cutting tools while the system is operating.
⑤
Use only the proper input power source voltage and check the voltage setting on the
⑥
E800Z control unit to prevent damage to the control unit or injury to the operator.
Degree of Risk
2