Configuration Of The Device - Technica Engineering 1000BASE-T1 User Manual

3 CONFIGURATION OF THE DEVICE

The 1000BASE-T1 MediaConverter_EMC is configured by four DIP-Switches on the
front of the device.
DIP-Switch
ON (up)
1
OFF (down)
ON (up)
2
OFF (down)
ON (up)
3
OFF (down)
ON (up)
4
OFF (down)
Table 3-1: Configuration of DIP-Switches
Note: In a 1000BASE-T1 Link one device must be set as Master, the other must be set
as Slave.
Note: In TestModes, press capital "T" in serial Terminal to select TestMode.
1000BASE-T1 MediaConverter EMC User Manual
Status
1000BASE-T1 Port is set to Master
1000BASE-T1 Port is set to Slave
1000BASE-T1 Mode
100BASE-T1 Mode
IEEE mode (A2)
Legacy Mode (A0)
Frame Generator Enable
Frame Generator Disable
Description
14