Installation Of Logs; Lava Rock; Flame Adjustment - Vermont Castings BHDR36 RN Installation Instructions & Homeowner's Manual

INSTALLATION OF LOGS

1 . Remove front glass. (See "Glass Removal" Section)
2. Remove logs from the packaging.
As with all plastics — these are not toys and
should be kept away from children and
infants.
3. Place rear log (BH2) on rear bracket (ensure log is
seated properly, leveled and centered to the unit), so it
will not move from side to side and it is firmly positioned
on the bracket.
4. Place front (BH1 on front log support. Use log's bottom
holes to locate it.
5. Place top left log (BH3) onto locator notches. Ensure
log is secure.
6. Place top right log (BH4) onto locator notches. Ensure
log is secure.
BH3
Top logs must be placed properly onto
notches.
BH4
BH2
BH1
Fig. 67
- 28 -

LAVA ROCK

The lava rock provided with this fireplace must be
placed on the firebox base on either side of the burner
assembly.
Under no circumstances should this lava
rock be placed on any part of the burner
assembly.

FLAME ADJUSTMENT

For fireplaces equipped with Hi/Lo valves, flame adjust-
ment is accomplished by rotating the Hi/Lo adjustment
knob located near the centre of the gas control. Fig. 68/
69.
LO
SIT VALVE
Turn
counterclockwise
to decrease
flame height
Honeywell Valve
HONEYWELL
VALVE
HI
Fig. 68
Turn clockwise
to increase
flame height
Fig. 69