Installation Of Logs; Burner Lava Rock Placement; Large Lava Rock; Flame & Temperature Adjustment - Vermont Castings DVRT41 Homeowner's Installation And Operating Manual

DVRT41 Direct Vent Gas Fireplace
Screw
Hearth Panels
Front of Unit
Fig. 47 Hearth panel location.

Installation of Logs

Remove front glass. (Refer to "Window Frame Assem-
bly Removal" Section, Fig. 46) Remove logs from
packaging.
As with all plastics — these are not toys
and should be kept away from children
and infants.
Log Identification Chart
LOGS
Log Front Left
Log Front Right
Log Rear
Log Crossover Left Top
Log Front Center
Refer to Figure 48.
1. Fit rear log (G7) in place. The two (2) underside
holes of the log fit over the two (2) pin studs of the
rear log bracket.
2. Place the front left log (G10). Position the front
branch between the second and third grates from
the left. The left end of this log with a slot will set
against the back of the first grate from the left.
3. Place the front right log (G6). Position the front
bottom recessed step of the log against the horizon-
tal bar of the front grate at the right. The center
bottom recessed step will set against the right end of
the burner housing.
4. Place burner lava rock and 1/3 of the bag of plati-
num embers on the front area of the burner. (Fig. 48)
5. Place the front center log (B129). Position the log
notch against the third grate from the right. The other
end of the log's bottom has a round recessed hole
that rests on top of the round knob located at the
center of the rear log.
24
Screw
Burner
Grate
FP1482
DVRT41
G10
G6
G7
G8
G9
6. Position the cross over left top log (G8) by locating
the bottom rectangular slot of this log onto the rear
log knob on the left. The other end of the log will set
on top of the left front log cutout.
7. Place large lava rock around the front grate area as
shown in Figure 48.
Log Crossover
Log Rear
Left Top
(G7)
(G8)
Log Front
Left
(F10)
Volcanic Lava Rock
LG339
Fig. 48 DVRT41 log, burner lava rock, platinum embers and
volcanic lava rock placement.

Burner Lava Rock Placement

Place burner lava rock on the burner in front of the front
logs. Do not place burner lava rock in the inside corners
of thefront logs.

Large Lava Rock

The large lava rock provided with this fireplace must be
placed on the firebox base around the sides of the
burner assembly and on the tray beneath the grate.
Under no circumstances should this
large lava rock be placed on any part of
the burner assembly.
Flame & Temperature Adjustment
For fireplaces equipped with Hi/Lo valves, flame adjust-
ment is accomplished by rotating the Hi/Lo adjustment
knob located near the centre of the gas control. (Fig. 49
or 50)
Honeywell Valve
Turn
counterclockwise
to decrease
flame height
Fig. 49 Flame adjustment knob for Honeywell valve.
Log Front Center
(G9)
Log
Front
Right
(G6)
Burner Lava Rock
and 1/3 of the bag
of Platinum
Embers
Turn clockwise
to increase
flame height
10006740