Operating Instructions; General Glass Information; Louvre Removal; Glass Cleaning - Vermont Castings RHEDV25 Installation Instructions & Homeowner's Manual

General Glass Information

Only ceramic glass approved by Vermont
Castings, Majestic Products may be used
for replacement on this unit.
1. The use of substitute glass will void all product
warranties.
2. Care must be taken to avoid breakage of the glass.
3. Under no circumstances should this appliance be
operated without glass properly installed, or with any
cracked or broken glass. Replacement of any glass
assembly as supplied by the manufacturer should be
done by a licensed qualified service person.

Louvre Removal

To remove
louvre pull
louvre up and
then lift out.
(Fig. 16)
FP444
Fig. 16 Louvre removal.

Glass Cleaning

It will be necessary to clean the glass periodically.
During start-up condensation, which is normal, forms
on the inside of the glass and causes lint, dust and
other airborne particles cling to the glass surface. Also
initial paint curing may deposit a slight film on the
glass. It is therefore recommended that the glass be
cleaned two or three times with a non-ammonia
household cleaner and warm water (we recommend
gas fireplace glass cleaner). After that the glass should
be cleaned two or three times during each heating
season depending on the circumstances present.
Clean glass after first two weeks of
operation.

Glass Frame Removal

1. Remove four (4) bottom fastening screws with a
3/8" nut driver. (Fig. 17)
2. Lift up and unhook glass frame at the top.
10000801
Vermont Castings, Majestic Products RHEDV Direct Vent Insert

Operating Instructions

2.
Louvre
1.
Glass Panel
10/24 Nut
Fig. 17 Remove four screws to remove glass frame.
Log Installation and Burner Lava Rock
1 . Remove front glass. (See "Glass Removal" section)
2. Remove logs from packaging.
3. Place rear log (JR4, KR4 or SR4) on rear bracket
(ensure log is seated properly, leveled and centered
to the unit), so it will not move from side to side and
is firmly positioned on the bracket.
4. Slip front ember log (JR1, KR1 or SR1) down in the
front deflector.
5. Place front left log (JR2 ,KR2 or SR2) on top
burner, left side. Use log's bottom holes to locate it
into the left bracket log locator studs.
6. Place front right log (JR3, KR3 or SR3 ) on top of
burner, right side. Use log's bottom holes to locate it
into the right bracket log locator studs.
7. Place burner lava rock material on top of burner.
(Fig. 18, 19 & 20 for proper location).
8. Place top right log (JR6, KR6 or SR6) onto locator
notches. Ensure log is secure.
9. Place top left log (JR5, KR5 or SR5) onto locator
notches. Ensure log is secure.
Top logs must be placed properly into
notches
Glass
Frame
FP1286
11