Over Torque - Siruba DL918 Manual

錯誤碼
異常現象說明
Error
Cause of the Problem
Code
選針盒通訊介面異常
Err 8
Operation Box
Communication Error
控制器過熱保護
Control Box Over
Err 20
Temperature
Protection
3. 是否有異物纏繞機頭或加工物是否過厚。
Check if any abnormal on machine head and if the textile is
too thick.
4. 排除後重新送電，若仍無法正常運轉，請通知廠商。
Reboot the control box after trouble fix. If the error code still
happens, please contact with qualified technician.
解決措施
Measurement and Solution
1. 關閉電源。
Turn off the power.
2. 檢查選針盒連接線(CN703)是否脫落、鬆動、破損。
Check the connection between operation box and control box
(CN703).
3. 排除後重新送電，若仍無法正常運轉，請通知廠商。
Turn on the power again. If the machine still cannot operate
normally, please contact with qualified technician.
1. 關閉電源，10 分鐘後重新送電。
Turn off the power. Reboot the control box after 10mins.
2. 控制器若仍有故障燈顯示，請通知廠商。
If the error code still happens, please exchange control box
and contact with qualified technician.
G 32