Operation; Control Functions; Operation Control Functions - Vermont Castings VC200 User Manual

Operation

Control Functions

Propane Tank Valve
WARNING : Never open the Tank Valve unless the Grill is being prepared for use, to prevent the pooling of
propane vapor.
Always open the Valve immediately before lighting the Grill, and always close it immediately after cooking has
been completed.
Burner Control Valves
On Models VC200 & VC400, four valves independently control gas flow to the Left, Right, Oven and Rotisserie
burners, as indicated on the front Control Panel (see Fig. 7).
On Model 100 there are two independent control valves for the main burners.
The OFF position is indicated by the dot above each knob. A full range of flame adjustment is available from
High to Low, (by turning a knob counterclockwise).
Electronic Ignition System
As you push the Ignitor Button, you will hear a series of clicks as the ignitor module generates an ignition
spark to the burners. The burner should light within four seconds. The system is powered by a single "AA"
battery. To remove or replace the battery, turn the push button knob counter clockwise, and carefully pull out
the spring and battery. Ensure that the positive end of the battery is in the down (bottom) position before
replacing the knob.
Models VC200 & 400
BUTTON
Fig. 7
Page 6