Operation-Lighting Instructions - Vermont Castings VANGUARD XE User Manual

14
GET ACQUAINTED
OPERATION - LIGHTING INSTRUCTIONS
A
B
C
WARNING: THE BURNER CONTROL KNOBS MUST BE IN THE "OFF" POSITION BEFORE TURNING ON THE LIQUID PROPANE
CYLINDER TANK VALVE. IF LEFT IN THE "ON" POSITION, WHEN THE LP CYLINDER VALVE IS OPENED,
THE "FLOW LIMITING DEVICE" FEATURE WILL ACTIVATE, LIMITING THE FLOW OF GAS FROM THE LP CYLINDER.
IF THIS SHOULD OCCUR, TURN "OFF" THE LP CYLINDER VALVE AND BURNER CONTROL KNOBS AND FOLLOW THE
"RESETTING THE FLOW LIMITING DEVICE INSTRUCTIONS".
WARNING: NEVER STAND WITH YOUR HEAD DIRECTLY OVER THE BARBECUE WHEN PREPARING TO LIGHT THE MAIN BURNERS,
TO PREVENT POSSIBLE BODILY INJURY.
CONTACT US: 1-844-586-4660
VC_manual_EN_Jan9.indd 14
LIGHT IT WITH THE IGNITION SYSTEM
Each burner is equipped with its own control knob
and ignites independently. Ignite the burners from Left
to Right.
1. Open the lid.
2. Check that all burner control knobs are in the
"OFF" position by pushing in and turn all knobs
clockwise (see image A).
ATTENTION: ALL BURNER CONTROL KNOBS MUST
BE IN THE "OFF" POSITION BEFORE OPENING THE
LP CYLINDER SHUT-OFF VALVE. IF ALL CONTROL
KNOBS ARE NOT "OFF" THE FLOW LIMITING
DEVICE IN THE REGULATOR WILL BE ACTIVATED,
LIMITING THE FLOW OF GAS TO THE GRILL.
3. SLOWLY, turn the LP cylinder shut-off valve counter
clockwise. Wait 30 seconds for pressure to stabilize.
ATTENTION: IF THE LP CYLINDER SHUT-OFF VALVE
IS OPENED TOO QUICKLY, THE FLOW LIMITING
DEVICE IN THE REGULATOR MAY BE ACTIVATED,
LIMITING THE FLOW OF GAS TO THE GRILL.
4. Light the far left burner first. Push in and
turn the control knob counterclockwise to the
Ignite/High ( ) position (see image B).
5. Push and hold the Electronic Ignition Button
(see image C). You will hear a clicking sound.
6. Check that the burner is lit by looking through the
cooking grates or look through the hole in the side of
the burner box, located under the side shelf.
7. If the burner lights correctly, repeat steps 4 through 6
to light the remaining burners.
8. If the burner does not light, turn the burner control
knob to the "OFF" position and wait 5 minutes to allow
the gas to clear before attempting to light again.
9. For issues lighting with the Electronic Ignition button,
see Troubleshooting section for a resolution, or follow
the match lighting procedure.
2019-01-09 10:06 AM