Operation; Control Functions - Vermont Castings VM448 User Manual

Control Functions

PROPANE TANK VALVE
Always open the Propane Tank Valve immediately before lighting the Grill and always close it immediately after
cooking has been completed.
WARNING
Never open the Propane Tank Valve unless the Grill is being prepared for use, to prevent the pooling of propane vapor.
Always open the Valve immediately before lighting the Grill, and always close it immediately after cooking has been
completed.
BURNER CONTROL VALVES
On Model VM448, three valves independently control gas flow to each burner.
On Model VM508, four valves independently control gas flow to each burner and a separate control valve for the
rotisserie burner.
On Model VM658, there are five independent control valves for the main burners, and a separate control valve for the
rotisserie burner.
The OFF position is indicated above each knob. A full range of flame adjustment is available from High to Low, (by
turning a knob counterclockwise).
Activating the Igniter
ELECTRONIC IGNITION SYSTEM
Turn on one or more burner control valves. Push and hold the burner igniter. As you push and hold the Igniter But-
ton, you will hear a series of clicks as the igniter module generates an ignition spark to the burners. The burner should
light within five seconds. Depending on which model you have, the system is powered by either a single "AA" or a
single "AAA" battery. Ensure the battery has been installed before using the igniter. To remove or replace the battery,
turn the push button knob counterclockwise, and carefully pull out the spring and battery. Ensure the positive end of
the battery is in the down (bottom) position before replacing the knob.
Figure 7
Cook Light
(if equipped)
Cook Light
Lumiere de cuisson
lux para cocine
Back Light
Lumiere arriere
Lux posterior
Back Light
(if equipped)
50004425
(Fig. 7)
Burner Igniter
CAUTION: READ ALL INSTRUCTIONS BEFORE LIGHTING
* Open lid before lighting
* Open cylinder / main gas valve
* Push and turn desired burner valve to "HIGH" and press igniter button
* If ignition does not occur within 5 seconds, turn valves to "OFF",
wait 5 minutes and repeat lighting procedure
* Accessible surfaces may become hot
* Do not operate rotisserie burner while main burners are on
Igniter
* Turn tank off when not in use
Allumoir
Encendido
Page 6
Rotisserie
(if equipped)
MISE EN GARDE: LISEZ TOUTESLES INSTRUCTIONS AVANT D'ALLUMER LE BBQ
* Ouvrez le couvercle du BBQ avant d'allumer ce dernier
* Ouvrez le robinet de la bouteille / vanne principale d'alimentation en gaz
* Enfoncez et tournez la vanne du bruleur desire en position "HIGH"
et appuyez sur le bouton d'allumage
* Si l'allumage ne se produit pas dans les 5 secondes, tournez les vannes en
position "OFF", attendez 5 minutes et repetez la procedure d'allumage
* Les surfaces a decouvert peuvent devenir brulantes
* El ne faut pas utiliser le bruleur de la rotisserie lorsque
les bruleurs prinicpaux sont allumes
* Fermer le robinet de la bouteille d'alimentation
en gaz lorsque l'appareil n'est pas utilise
ROTISSERIE

Operation

PRECAUCIOIN: LEA TODAS LAS INSTRUCCIONES
ANTES DE ENCENDER LA UNIDAD
* Abra la tapa antes del encendido
* Abra la valvula del tanque / de gas
* Presione y gire la valvula del quemador a "HIGH"
y presione el boton de ignicion
* Si el quemador no enciende a mas tardar en
5 segundos, gire las valvulas a "OFF",
espere 5 minutos y repita el
procedimiento de encendido
* Las superficies descubiertas
pueden calentarse
* No opere el quemador del
rostizedor mientras los
quemadores principales estan
encendidos
* Apague el tanque
con no esta en uso
B167