Heater Shell Assembly - Vermont Castings 2950 Installation And Operating Manual

Vermont Castings Pinnacle & Stardance Direct Vent - Rear Vent Gas Heaters

Heater Shell Assembly

Unpack the cast iron stove shell parts from the ship-
ping carton. Inspect each part for shipping damage and
set them aside on a protective surface. Porcelain
enamelled surfaces are fragile. Handle porcelain
enamelled castings gently.
1. Use only the rear shroud supplied with this firebox.
Attach the rear shroud to the left side plate by
aligning the key holes with the two wingbolts (A)
installed in the side. (Fig. 13) If necessary, turn the
wingbolts to orient the blades vertically. Slide the
shroud downward to engage it behind each washer
(B) and then tighten the wingbolts.
2. Attach the Right Side Plate to the Rear Shroud. (Fig.
14) Align the two side plates to be perpendicular to
the Rear Shroud as in Figure 15.
3. Move the entire assembly close to the stove's final
position.
PDV20
C
SDVR
ST323/470
Fig. 13 Fasten the left side to the rear shroud.
14
B
A
B
A
B
A
B
A
C
PDV20
SDVR
Fig. 14 Fasten the right side to the rear shroud.
Fig. 15 Align both sides with rear shroud.
B
A
B
A
ST324
B
A
B
A
ST471
90°
ST106
20003457