Vermont Castings 2950 Installation And Operating Manual page 36

Vermont Castings Pinnacle & Stardance Direct Vent - Rear Vent Gas Heaters
7. Hold the burner at the right hand side and lift to
clear the right burner leg. Then pull to the right to
clear the injectors on the left hand side.
8. Remove injector orifices from left burner leg using
1/2" wrench. (Fig. 74)
9. Install conversion orifices. (See Table 2)
Models 2995, 2996 (R Models) Only
10.Remove cap from Hi-Lo knob. This can be accom-
plished by lifting the plastic cap off the screw. (Fig.
70)
11.Remove the screw from center of Hi-Lo knob with
small screwdriver turning counterclockwise. (Fig. 70)
12.Insert blue painted screw when converting to natural
gas and red painted screw when converting to LP.
Cap
Lift Open
Hi-Lo
Knob
Fig. 70 Remove center screw from Hi-Lo knob.
13. Tighten screw, replace cap.
14. Locat pilot. (Fig. 69)
15. Replace pilot orifice:
Pilot Type 1
•
Remove pilot hood by lifting up. (Fig. 71) NOTE: It
is not necessary to remove the pilot tube for conver-
sion.
•
Remove pilot orifice with allen wrench. (Fig. 72)
•
Install the conversion orifice.
•
Reinstall pilot hood. Be sure to align hood with
index tab.
Pilot Hood
Pilot
Bracket
Fig. 71 Remove pilot hood.
36
Center Screw
CO100
CO105a
Index Tab
Snap Ring
CO106a
Fig. 72 Remove pilot orifice.
Pilot type 2
•
Loosen pilot hood turning counterclockwise using a
7/16" wrench. (Fig. 73)
•
Remove pilot orifice with needlenose pliers. (Fig.
74)
•
Install the conversion orifice.
•
Reinstall pilot hood and tighten until mark on pilot
hood aligns with mark on pilot bracket.
Index
Marks
Pilot Bracket
Fig. 73 Remove pilot hood. (Your pilot may have a different
appearance.)
Fig. 74 Remove pilot orifice.
Allen Wrench
Pilot Hood
CO105
Pilot
Orifice
CO106b
20003457