Programming
IMPORTANT:
Before any programming sequence, make sure
that your door is open and unlocked.
For all programming sequences below, success is indicated
when the Kwikset button flashes green 2 times and you hear
2 beeps.
If unsuccessful, the Kwikset button will flash red 3 times and
you will hear 3 beeps.
Note: If the lock is muted, you will not hear the lock beeping.
How to change your Programming Code
The Programming Code (PC) will not unlock your door. It is an
added security feature that is used to set up all functions.
The default PC is 0-0-0-0. It is recommended that you change it
to a code of your own.
1. Enter your existing PC.
2. Press
4
3. Enter a new PC. It must be between 4 and 10 digits.
4. Press
Kwikset: 1-800-327-5625 • www.kwikset.com
How to add User Codes
A total of 6 User Codes (and a temporary one-time User Code)
may be programmed. Do not program a User Code that is the
same as your PC.
1. Enter your PC.
2. Press
1
3. Enter a new User Code. It must be between 4 and 10 digits.
4. Press
5. Test the code: While your door is open, lock it and enter your
new User Code to make sure it unlocks the door.
8 / 10
How to delete individual User Codes
The lock is pre-programmed with a default User Code of 1-2-3-4.
It is recommended that you delete this code.
1. Enter your existing PC.
2. Press
2
3. Enter the User Code you wish to delete.
4. Press
5. Test the code: While your door is open, lock it and enter the
User Code to make sure it no longer unlocks the door.
© 2016 Spectrum Brands, Inc.