Initial Set - Up With Fire Panel And Winpara - Bosch LSN Product Documentation

Product Documentation of the LSN Radio Fire Detection System

6. Initial Set - Up with Fire Panel and WinPara

D Connect the LSN and supply voltage to RF expan-
sion module FK 100 LSN.
⇒ The red LED on FK 100 LSN lights up for a few sec-
onds, after which the yellow LED flashes slowly to
indicate that FK 100 LSN is in standby mode.
D Programm
FK 100 LSN on the programming PC using Win-
Para and load all RF detectors to be set in the fire
panel.
D Activate the menu item "Reset FK100" in WinPara
under FK 100 LSN.
⇒ The red LED on FK 100 LSN lights up briefly, then
the green and yellow LEDs start to flash rapidly to
indicate a frequency search (max. 10 min.).
⇒ Following a successful frequency search, the yel-
low LED goes out to indicate that it is now possible
to log on to the RF detector.
Log RF detector on to RF expansion module:
D Insert the batteries and secure the cables,
as shown in the diagram on the right.
⇒ The LED on the detector should flash slowly.
D If the LED is flashing rapidly, press the new button
and hold it for at least 3 seconds.
⇒ The detector will be reset to its default settings and
the red LED will flash slowly.
D Insert the detector in the base within 10 minutes of
inserting the batteries!
⇒ Following a successful system logon (duration:
15 sec. to a max. of 10 mins), the red LED will go
out and then flashes again for two minutes to indi-
cate the field strength.
Flashes/sec.
4
3
2
1
the entire system
Field strength
High
Moderate
Low
Very low
Seite 16 von 32
including
LED green
LED yellow
LED red
Button new
LED
red
Effect
Within field strength range adequate for Within field strength range adequate for
detector use!
Impermissible field strength range! Impermissible field strength range!
Improve detector positioning!
PI - 32.15a
601-F.01U.002.708
A3.en / 28.12.2004
ST-FIR/ PRM1 / deh