rough country 928511900 Installation Instructions

Jl/jlu mesh bimini top

Advertisement

Congratulations on your purchase of a Rough Country Mesh Top. Check the kit hardware against the parts list. Confirm
the correct model was ordered and received. A general knowledge is useful and understanding on top removal on the
Jeep.
We are excited that you have chosen a Rough Country Mesh Bimini Top. These high quality tops are designed to en-
hance your fair weather driving pleasure while providing needed shade while driving in the hot sun and protecting the
interior. Please note that it is important that you become familiar with the installation process of this top by reading the
following instruction sheet and warnings thoroughly. Though we have used only the finest materials in creating this top,
any product that is exposed to the elements requires some general maintenance to keep it looking like new. Please see
page 6 for these important maintenance tips. Please also note that it is normal for the mesh fabric to contract and wrinkle
when stored in the shipping carton. In a few days the fabric will relax and wrinkles will disappear.
If any questions arise, please call Rough Country customer service.
Instruction Sheet Strap Installation Note: (all versions)
Installing the Rough Country Mesh tops entails the wrapping of nylon webbing around sev-
eral locations on your factory installed sport bar. In all cases, the straps are to be wrapped
around the sport bar and not just around the door surround.
Threading Straps through Buckles:
Throughout the installation, you will need to thread webbing straps through buckles several
times. Please review the picture for correct strap routing through the buckles. As a rule of
thumb, run the strap below and through the sewn side of the buckle first and then back
down through the end of the buckle. Tighten the strap by simply pulling the exposed web-
bing after threading the strap through the buckle.
Loss of vehicle control involves risk of death or serious injury, particularly to parts of your body not restrained within the
vehicle. This product is intended for moderate weather protection only and should not be relied upon to contain
occupants in the event of an accident or to protect from either ground contact or falling objects. To reduce
risk of accident or injury:
ALWAYS WEAR SEATBELTS
Always keep head, arms & body parts within vehicle.
Fully secure or stow the soft top before driving according to instructions. Never try to latch or fold soft top
while driving. Do not use if damaged or worn.
Read and follow all instructions & warnings accompanying this product, in your vehicle owner's manual and
Off Road Driving Supplement
Remove your factory hard or soft top before installation. For those vehicles with a factory soft top,
you will NOT be using your factory soft top header for this installation.
The Rough Country Mesh Bimini top series are designed as an easy-on, easy off sun shade for your Jeep. The tight
mesh weave is specially designed to block the heat caused by the sun while letting light and air to flow freely. The instal-
lation of these products is easy and requires no tools or windshield header, and allows this product to be left on while
you run your hard or your soft top. Enjoy the shade and thank you for purchasing Rough Country products!
JL/JLU Mesh Bimini Top Installation Instructions.
928511900

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 928511900 and is the answer not in the manual?

Questions and answers

Summary of Contents for rough country 928511900

  • Page 1 Jeep. We are excited that you have chosen a Rough Country Mesh Bimini Top. These high quality tops are designed to en- hance your fair weather driving pleasure while providing needed shade while driving in the hot sun and protecting the interior.
  • Page 2 2018 JL/JLU Rough Country Mesh Bimini Top Installation 1. Remove your factory hard top or soft top. 2. Locate the front section of your top and drape the front mesh fabric over the top of your Jeep with the flat straight edge facing forward.
  • Page 3 2019 JL/JLU Rough Country Mesh Full (Rear) Bimini Top Installation 1. Remove your factory hard top or soft top. 2. On the Rear Mesh, locate the two center buckle straps. 3. Thread the supplied hook straps into the center buckles and hook the straps into the holes located in Photo 1 & 2 .
  • Page 4 8. This step will require the use of a T25 Torx bit and driver. You will be removing two Torx screws from the rear roll bar and re-installing them back into the same holes. Locate the two center cutouts on the rear of the Roll bar. See Photo 7.
  • Page 5 Maintenance Tips Your Rough Country Mesh Bimini top is made of the finest materials available but to keep it looking new and for the maxi- mum possible wear, it will need periodic cleaning and basic maintenance. The main threat to your mesh top is pollutants, dirt, and grime.

Table of Contents