Topping Up The Hydraulic System; Lubrication; Check The Tilt Safety Device; Inspecting The Scissor Mechanism - HOLLAND LIFT HL-190 D25 4WD/P/N User Manual

HL-190 D25 4WD/P/N / HL-220 D25 4WD/P/N
B-165DL25 4WD/P/N / B-195DL25 4WD/P/N
Rev. A
Installing the safety brackets
1.
Make sure there is no load on the platform.
2.
Make sure the scissor mechanism is opened far enough so that the safety brackets (1) can be
installed.
3.
Remove the lock bolts (2).
4.
Rotate the safety brackets a quarter of a turn upwards as far as the stops (3).
5.
Lower the platform until the scissor axle stumps (4) fall into the recess in the brackets.
Removing the safety brackets
1.
Raise the scissor mechanism slightly so that the safety brackets come free.
2.
Rotate the safety brackets a quarter of a turn back into the rest position.
3.
Use the lock bolts to lock the safety brackets.

Topping up the hydraulic system

8.3.2
Note!
Only top up the hydraulic system with Shell Tellus T32.
Fill the tank to half of the volume indicated on the gauge glass.


Lubrication

8.3.3
Note!
Only use EP NLGI-kl.2 + Teflon
The warranty will no longer be valid if grease with a different composition is used.
1.
Fit the safety brackets.
2.
Use the optional automatic lubrication system or manually spray the correct quantity of
grease into all of the indicated lubrication points until it escapes from behind the washers.
3.
Carefully remove any excess grease.

Check the tilt safety device

8.3.4
Press the top edge of the tilt safety device.

• A warning signal should be heard.

Inspecting the scissor mechanism

8.3.5
The scissor mechanism's hinged points must be checked for play, wear and damage by an expert
every five years. A hinged point will be rejected if one or more of the following rejection criteria apply
to the shaft or the bearing.
Rejection criteria:
The shaft or the bearing has visible damage.

The surface of the shaft or the bearing has a roughness greater than 1 m.

The chrome layer on the shaft or the bearing is damaged.

The depth of the bearing's grease chamber is less than 0.40 mm.

The shaft or the bearing is not sufficiently lubricated.

The shaft or the bearing has become stuck.

5/2/18

(< 2 % drying agent) grease to lubricate the scissor lift. 
Page 42