Topping Up The Hydraulic System; Lubrication; Check The Tilt Safety Device - HOLLAND LIFT HL-140 E12 Instruction Manual

HL-140 E12 / HL-160 E12 / HL-190 E12 / HL-220 E12
N-120EL12 / N-140EL12 / N-165EL12 / N-195EL12
Rev. F
Engaging the safety prop
1.
Make sure there is no load on the platform.
2.
Make sure the scissor mechanism is opened far enough so that the safety prop (1) can be
engaged.
3.
Remove the lock bolt (4).
4.
Lift the safety prop (1) out of the retainer and rotate it a quarter turn upwards as far as the
stop (3).
5.
Lower the platform until the stub shaft (2) falls into the recess in the safety prop.
Disengaging the safety prop
1.
Raise the scissor mechanism slightly to release the safety prop.
2.
Swing the safety prop a quarter turn back into the storage position.
3.
Lower the safety prop into the retainer.

Topping up the hydraulic system

7.3.2
Note!
First disconnect the interconnection hose (on top of the tank) between the two tanks so the air
can exit the tank.
Note!
Only top up the hydraulic system with TOTAL Equivis ZS 32.
Fill the tank until the oil level reaches half the volume indicated on the gauge glass.


Lubrication

7.3.3
Note!
Only use EP NLGI-kl.2 + Teflon (< 2% dry material) grease to lubricate the scissor lift. 
The warranty will be void if a different type of grease is used.
1.
Engage the safety prop.
2.
Manually pump the correct quantity of grease into all the indicated lubrication points until
plenty of grease escapes from behind the washers.
3.
Carefully remove any excess grease.

Check the tilt safety device

7.3.4
Press the tilt safety device in both the longitudinal and transverse direction.

• A warning signal will sound.
8/2/18
Page 46