Automatically Levelling The Prop Cylinders - HOLLAND LIFT HL-190 D25 4WD/P/N User Manual

HL-190 D25 4WD/P/N / HL-220 D25 4WD/P/N
B-165DL25 4WD/P/N / B-195DL25 4WD/P/N
Rev. A

Automatically levelling the prop cylinders

6.7
The props can be used to level the scissor lift when it is on an uneven surface.
The props can only be operated when the platform is at a height of less than 4 metres. It is not
possible to drive the scissor lift when the props are not fully retracted.
The "Props retracted" light on the control panel will then not be lit.
Push the switch forwards until the light is lit continuously and the safety device is deactivated.
The switch on the control panel must be pushed backwards before the props can be extended.
Press the switch (11) until the "Props extended" light (12) is lit continuously.
9
10
11
12
13
All 4 props will now be touching the ground. The scissor lift will be automatically levelled if the switch
is kept pressed. This is indicated by the flashing "Automatic levelling" light (12).
Keep the switch pressed until the light is lit continuously. The scissor lift will then be level.
5/2/18
14
Automatic levelling
15 16
Page 34