Room Controller Connections - Evinox ModuSat FS Series Installation Manual

5.3

Room controller connections

The Room controller is a white ABS box with a graphic display. It should be installed in the
main living area of the dwelling. It must be connected to the control wiring board within the
ModuSat (please refer to the electrical diagram) using a 4x0.35 mm2 screened cable. The
cable must not be installed adjacent to other 220/240 Volt (AC). The ModuSat room
controller's power is supplied by the ModuSat board and does not require batteries or
additional power cabling.
Dimensions: H= 80 mm, L= 130 mm, D= 22 mm
To open the cover to access connections, use a screwdriver in the tab at the bottom as
shown below
40