Modusat Fs Positioning - Evinox ModuSat FS Series Installation Manual

The ModuSat FS may have been transported and handled many times if you consider the
on-site storage, handling and installation, therefore it is vitally important that all unions and
connections are checked and tightened as required. In case of damage please contact
Evinox immediately. Packaging materials must be properly disposed of in line with current
environmental guidelines.
It is recommended that at least two people perform any lift. Clear the route of the
carton from point of delivery to point of installation. Take care to avoid trip
hazards, slippery or wet surfaces and where possible climbing steps and stairs.
Always seek assistance if required. If a sack truck is used it is recommended that the
carton is strapped to the truck, to prevent the unit from falling.
When unpacking the unit from the carton, it is recommended that at least two people
perform any lift. It is recommended that the bottom end of the carton is cut and the carton
flaps are opened.
Ensure the protective cover over the ModuSat FS pipe connections on the top of unit are
kept in place to prevent ingress of any debris, and then remove the carton by sliding it up
over the top of the unit.
Take care when lifting this appliance and ensure your back is kept straight at all
times. Avoid twisting at the waist - reposition the feet instead.
Avoid upper body bending when holding the appliance and keep the ModuSat FS
as close to the body as possible. Safety footwear and gloves are recommended.
PPE should be used when lifting this appliance - to protect against any injury
caused by possible sharp edges and also to ensure a good grip.
3.2

ModuSat FS positioning

There are no specific requirements with regards to location and venting / airflow.
However, to ensure the correct operation the temperature of the location of the
unit should, whilst running, not exceed 40 °C with the humidity between 15% to
85% RH.
The unit must be sheltered from the extremes of weather and temperature; it
should therefore not be installed or stored outdoors. The ModuSat FS is
designed to be used internally and within a well protected area.
The equipment must be level and the floor loading strength must be suitable to
bear the weight of the equipment (refer to technical characteristics for weights).
A minimum 600mm clearance should be left on the front and a minimum 50mm
on both sides of the unit for
Dimensions for safety bend / drains should be as per the guidelines within this
document and current building and G3 regulations. Please note: - As the P&T
discharge can exit the unit on either side, once it has been decided on the final discharge
route, additional space must be allowed on the relevant side in line with G3 regulations.
Ensure that the environment where the ModuSat FS is to be installed complies with
current regulations and guidelines.
access, maintenance and parts replacement.
22