Checks Before Connecting The Modusat Fs - Evinox ModuSat FS Series Installation Manual

3.3

Checks before connecting the ModuSat FS

Before connecting the ModuSat FS the primary and secondary system
must be thoroughly flushed to remove all residues, dirt etc, that may be
present and would compromise / cause damage to the appliance.
The system should also be thoroughly rinsed to ensure all cleaning
products used are fully removed.
Disconnect the electrical power before any installation works.
The unit requires a 220/240Volt (AC) – 50Hz supply, check the Line and Phase
polarity. Protect the cables to prevent any damage.
Make sure that there is an efficient, reliable earth connection to protect against possible
electric shocks, in line with current electrical regulations.
All electrical wiring should be installed / checked by qualified personnel in line
with current regulations. EVINOX are not liable for damage caused by incorrect
electric connections or faulty wiring.
The ModuSat should be provided with additional fused protection. This will be via
a suitable rated fused switch adjacent to the HIU position.
23