Use Of Pre-Installation Rig - Evinox ModuSat FS Series Installation Manual

3.4

Use of Pre-installation Rig

A pre-installation rig is available upon request on a sale or return basis. It consists of a
back panel constructed of steel. This will enable the installer to arrange the piping entering
and leaving the unit during first fix prior to the unit being delivered / installed. The
configuration of the pre-installation rig will be as per the unit being supplied and the project
requirements.
HOW TO INSTALL PRE-
INSTALLATION RIG
STEP1: Temporarily fix the Pre-
Installation Rig against the wall in the
required position.
STEP2: Fit the Evinox Flushing Bypass
& Valve Kit to the rig and then make
final connections to the pipework
running to the HIU.
STEP3: Shut off isolation valves,
pressure test pipework and then
disconnect the valve unions and lift
away the Pre-Installation Rig leaving
the valves ready for the ModuSat
arrival.
STEP4: Take the Pre-Installation Rig to
the next apartment and repeat the
process.
NB: Please take care of the Pre-
Installation Rig as this is typically
purchased on Sale and Return basis.
Damaged pre-installation rigs cannot
be returned for credit.
Please refer to section 2.2 for the
relevant model dimensions and typical
connection configuration.
.
Typical Evinox Valve Kit Installation
24